Bird in a Tree Trio Bracelets

Design by Tracy Gonzales for TierraCast

Supplies (for 3 bracelets - approx. 7"-9" inside circumference)

  • 8 - 6mm Pagoda Cord End (01-0201)
  • 3 Bird in a Tree Link (94-3186)
  • 7 - 6mm Round Jumpring (01-0025)
  • 2 - 4mm Round Jumpring (01-0024)
  • 2 - 12x7mm Lobster Clasp (01-0110)
  • 24" 5-6mm Round Cotton Cord (8" per bracelet)
  • Scissors
  • Chain or Flat Nose Pliers (2)
  • E6000 Adhesive or gel super glue
  • Measuring Tape

Tip: If cord is fraying or is a tight fit in Cord End, wrap a 1/8" strip of tape snugly around end.

Tip: Watch our technique videos playlist on YouTube (look for videos on jumprings and cord ends)

Bracelet A

Use adhesive to glue one cord end onto one piece of cord, hole facing out, and allow to dry.

Use one 6mm jumpring to attach lobster clasp to the cord end.

Use one 6mm jumpring to attach one side of Tree Link to lobster clasp.

Wrap bracelet around wrist to determine fit. Shorten measured length by 3/8" to allow for second cord end and jumpring, then trim excess cord.

Repeat 1st step, then use 6mm jupring to attach cord end to link.

Bracelet B

Repeat 1st step from Bracelet A.

Use one 4mm jumpring to attach Tree Link to the cord end.

Make a fist, and measure the distance between centers of pinky and index knuckles on the back of your hand. 

Form bracelet into circle with inside diameter of measurement from the 3rd step, then trim cord 1/4" from end of link.

Repeat 1st step, then use 4mm jumpring to attach cord end to link.

Bracelet C

Follow directions for Bracelet B.

Cut bracelet in half at back, the trim addition 1/2"-1" off each end (more if you want a smaller fit).

Glue one cord end to each end and allow to dry.

Use one 6mm jumpring to attach lobster clasp at one end. Attach final jumpring at the other end. 

Back to Jewelry and Beading Projects